Moog Taurus 3 Specifications download pdf (Page 14)

Page 16

Taurus 3 User’s Manual - The Components

Page 17

Taurus 3 User’s Manual - The Components

B.2. Arpeggiator

Arpeggiator Panel Controls:

ORDER:

Selects the arpeggiator Order parameter, which determines the order in which notes are sequenced. The

available selections are UP, DN (Down), and ORDER where:

UP - Notes are sequenced from the lowest note to the highest

DN - Notes are sequenced from the highest note to the lowest

ORDER - Notes are sequenced in the order that the note stack was lled

PATTERN:

Selects the arpeggiator Pattern parameter, which determines the sequence playback mode. The available

modes are LOOP, B/F (Back/Forth) & ONCE, where:

LOOP - When the sequence reaches the end, it loops back to the starting point

B/F - When the sequence reaches the end, it reverses direction and returns to the starting point

ONCE - The sequence makes a single pass and then stops

OCTAVE:

Selects the arpeggiator Octave parameter, which determines the overall note range of the sequence. The

available values are -2.1, -2, -1, 0, 1, 2, 2.1. With the exception of ‘-2.1’ and ‘2.1’, all values specify octaves.

When these values are selected, the sequence will play the original note entered, and then the same note

transposed by octaves until the octave limit is reached. For ‘-2.1’ and ‘2.1’ values, the sequence will trans-

pose up or down two octaves and then back one octave towards the original pitch. For example, if the

arpeggiator was sequencing a single note (‘C1’), and ‘2.1’ was chosen as the Octave value, the sequence

would be ‘C1 - C2 - C3 - C2’.

For more on Arpeggiator operations, see Appendix A - Arpeggiator Examples.

The Arpeggiator is a note pattern generator based

on the notes played on the pedalboard and stored

in the note stack (the note stack is a ‘memory

bank’ for the arpeggiator). For any note or series

of notes that are played, the arpeggiated pattern is

determined by the Order, Pattern and Octave set-

tings, along with the Latch and other parameters in

the Advanced Preset menu.

The Arpeggiator control panel provides controls

to select the Order, Pattern, Octave, and Latch

parameter values, as well as Arp ON/OFF and

Arp Rate.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

Moog Taurus 3 Specifications Page 14