www.moogvideolarm.comF C H 3 6 0Fusion Camera Housing with Panomorph Lens OptionsInstallation and Operation Instructions for the following models:FCH3
NOTE: To maximize power for the camera and heater option, the unit requires that you calibrate the enclosure. During calibration, the onboard proc
Connect the network cable from the midspan to the connector that is labeled “To Network” connect the camera to the connector labeled “To Camera”. Whe
The camera tray can be securely locked into place with the provided 3.5 x 7mm screw. Tighten it through the rear tray tab..• La bandeja de la cámar
If your housing has a sunshield, adjust it for your particular lighting conditions by loosening (2) screws..• Si su cubierta tiene un sunshield, aj
123456# Part Number Description1 RPVL3948 FCH Camera Tray2 RPVL3950 FCH Heater + Bracket3 RP76VL2016 FCH 12VDC
Product Registration/WarrantyThank you for choosing Moog Videolarm. We value your patronage and are solely committed to providing you with the highes
IMPORTANT SAFEGUARDS SAFETY PRECAUTIONSUNPACKINGSERVICE1 Read these instructions.2 Keep these instructions. 3 Heed all warnings 4 Follow
Limited Warranty for Moog Videolarm Products Moog Videolarm warrants these products to be free from defects in material or workmanship as follows:PROD
Contents of Box24Vac: 17 watts Heater (16 watts), Blower (1 watt)12Vdc: 7 watts Heater (6 watts), Blower (1 watt)PoE: IEEE802.atCamera Power:
If you are running a conduit to the housing, rst install the appropriate tting to the wall mount. • Si usted está funcionando con un conducto a l
Hinge housing away from mount by loosening (2) rear screws. • Abisagre la cubierta lejos del montaje aojando (2) los tornillos posteriores. • Art
Pass cables through wiring membranes (use screwdriver to pierce).. • Pase los cables a través de las membranas del cableado (el destornillador del u
Mount camera with ¼-20 hardware. Position the lens as shown and center with the spacers as needed, conrmtabs are securely snapped into place. NOTE
- Terminate incoming voltage as shown.- Install shunts on “12Vdc” jumpers as shown.- Power output to camera will be 12Vdc.• Termine el voltaje entrant
Comments to this Manuals