Moog P1800 Operations Instructions

Moog Inc. Sensor and Surveillance Systems3650 Woodhead Drive Northbrook, IL. USA 60062 +1.847.498.0700 Fax: +1.847.498.1258 www.moogS3.comP1800 and

Anchor Jig AssemblyAnchor Jig Kit Parts ListSingle Straps (4)Cross Strap (1)3/4" - 10 Bolts (4)3/4" Flat Washers (4)3/4" - 10 Hex Nut (

IMPORTANT SAFEGUARDS SAFETY PRECAUTIONSUNPACKINGSERVICE1 Read these instructions.2 Keep these instructions. 3 Heed all warnings 4 Follow

Product Warranty RegistrationRegister Your Products Onlinewww.moogS3.com/technical-support/product-registrationMoog values your patronage. We are sole

Limited Warranty for Moog ProductsMoog - Decatur Operations, subsequently referred to as “Manufacturer,” warrants these products to be free from defec

! Please read these instructions carefully before proceeding, and heed all cautions.STANDARD INSTALLATION PROCEDUREINCLUDES MODELS: P1800!NOTE: If

3. FOR ANCHOR BOLT INSTALLATIONS: Pour concrete per manufacturer's directions, making sure that the wiring conduit is in the center of the pad.

CAUTION: Pull all slack in the wiring as you lift the pole into position to keep from pinching and

4Wiring Inside the NEMA BoxBNC connector (use crimped-on method) NOTE: This unit MUST be grounded. If you do not have ground on the incoming power

ACNeutralGround115 VAC Incoming Power12345624 VAC power pre-connected1 RED RX Control Data2 ORANGE RX Control