Moog 500 Series User Manual download pdf (Page 14)

TAP/CV INPUT

TAP TEMPO

The TAP TEMPO input on the Analog Delay can be used to control either

the DELAY TIME or the LFO RATE.

SET A TEMPO: Simply plug in a Moog FS-1 footswitch and tap at the de-

sired tempo in quarter notes. After the third tap the Delay will begin calcu-

lating the tempo and keep the average tempo as you continue to tap.

SET A NEW TEMPO: Wait ﬁve seconds and then press the switch three

times to set a new tempo.

CHANGE TAP TEMPO DESTINATION: use the TAP TEMPO DESTINATION

control on the plugin/stand-alone editor, or press and hold the tap tempo

footswitch to toggle between DELAY TIME and LFO RATE. The destina-

tion LED (DELAY TIME or LFO RATE) will ﬂash green one time to indicate

the destination. The LED indicator for the function being controlled by Tap

Tempo will ﬂash green and in sync with the chosen tempo

NOTE: When either destination is synchronized to MIDI Clock, Tap Tempo is

disabled.

LFO EFFECTS ON DELAY TIME SET USING TAP TEMPO

If you set the DELAY TIME via Tap Tempo and then modulate the TIME with

the LFO, you may ﬁnd that your tapped tempo has changed. This is due to

the LFO averaging the DELAY TIME.

CONTROL VOLTAGE

DELAY TIME: A setting of 0 volts or GROUND sets the DELAY TIME to the

shortest possible time while a 5v setting sets the TIME to the longest pos-

sible time, based on the current 0.5x/1.0x and TIME MULTIPLIER settings.

To modify the DELAY TIME from minimum to maximum via control voltage

or expression pedal, set the DELAY TIME control to the lowest setting via

the panel, editor or MIDI message.

FEEDBACK: A setting of 0 volts or GROUND allows for no feedback while

a 5v setting gives inﬁnite feedback. To change the FEEDBACK amount

from zero to inﬁnite via control voltage or expression pedal, set the FEED-

BACK to the lowest setting via the panel, editor or MIDI message.

LFO RATE – A setting of 0 volts or GROUND sets LFO Rate to 5 Hz while a

5v setting sets the RATE to 50 Hz. To modify the LFO RATE from minimum

to maximum via control voltage or expression pedal, set the LFO RATE to

the lowest setting via the editor or MIDI message.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Moog 500 Series User Manual Page 14