Moog P1600 Operations Instructions download pdf (Page 4)

Part 1: Site Preparation

NOTE: Special attention must be paid to the size of

the wiring conduit and its location within the

concrete foundation and jig (if applicable.)

The Wiring Conduit can be up to 2" in

diameter. Use reducers if necessary.

Also, make sure that the Wiring Conduit is

in the center of the foundation and Anchor

Jig during installation (Figure 1).

1" diameter

maximum

Figure 1

Wiring conduit

Up to 2" in

diameter

Part 1: Site Preparation

1. Select a suitable site for the P1600 and prepare the pad site

using a hole 36" x 36" x 36" deep. The top of the concrete

foundation should be ﬂ ush with the ground.

CALL BEFORE DIGGING! Be sure that there are no

underground electric or phone cables, gas or water

lines in the area where the pole will be located.

2525 Park Central Blvd. • Decatur, Ga 30035 • (770) 987-7550 • 800-554-1124 U.S. &

Canada • www.videolarm.com

Part 1: Site Preparation

To help reinforce the concrete foundation, place (12) 1/2” diameter x 32” long Reinforcement

Bars (”rebar”) as shown in figure 2. Use suitable preparation methods to place the rebar.

24"

36"

24"

36"

24"

32"

PV4 Anchor jig (if applicable)

12"

32"

36"

Figure 2

Reinforcement bars (12)

1 2

1 2 3 4 5 6 7 8 9

No comments

Moog P1600 Operations Instructions Page 4