Moog MP-201 User Manual download pdf (Page 18)

MP-201 User’s Manual

Page 20

MP-201 User’s Manual

Page 21

Edit Mode

Edit Mode allows you to edit the parameters of a Preset. Edit Mode can be entered

from Single Channel Mode or Quad Channel Mode simply by pressing EDIT or by

pressing FS2 & FS4 simultaneously.

In Edit Mode, the VALUE Encoder or footswitches 1 & 2 (FS1 and FS2) are used to

scroll through the edit menus. In any menu, pressing the Encoder pushswitch or FS4

moves the cursor to the bottom line of the LCD, where you can change the edit value

using the VALUE Encoder. Pressing the Encoder pushswitch or FS4 again moves the

cursor back to the top line of the LCD.

NOTE: When the cursor appears in the value eld, the footpedal

is used to set Footpedal Parameter values, such as the Heel,

Toe and Initial values. The VALUE encoder can be used for ‘ne’

adjustments to these values.

Footswitch 3 (FS3) is used to select the Channel or Preset MIDI routing for editing

(CH1, CH2, CH3, CH4, or ALL). You can change the current Channel (or MIDI ALL)

at any time while in Edit Mode.

To exit from Edit Mode at any time, press the EDIT button again. Note that any

changes made to Preset parameters are maintained until the Preset number is

changed, but will be lost if you do not save them (see ‘Storing Presets’, page 32).

NOTE: When you edit the ‘Heel’, ‘Toe’, an ‘Initial’ values in Expres-

sion Mode and LFO Mode, and the ‘Rate’, ‘Amount’ and ‘Offset’

values in LFO Mode, the footpedal has no effect on any other

Channel, or any other parameter. The CV and MIDI outputs reect

the voltage/MIDI CC values of the footpedal position, allowing you to

‘hear’ what the actual values are.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

No comments

Moog MP-201 User Manual Page 18