Moog MP-201 User Manual download pdf (Page 25)

MP-201 User’s Manual

Page 26

MP-201 User’s Manual

Page 27

DESCRIPTION:

When CHANNEL MODE is set to LFO, the selected channel will output either an LFO

CV or Noise, depending on how the LFO parameter is programmed.

LFO WAVEFORM allows you to choose either the waveform of the Low Frequency

Oscillator, or Noise for the selected Channel. See the section entitled Low Frequency

Oscillator Parameters (page 33) for more information.

FPEDAL MODE (Footpedal Mode) selects the function of the footpedal effect on the

LFO for the selected channel. When RATE is selected, the footpedal controls the LFO

Rate (or the MIDI Clock divider value if LFO SYNC is set to MIDI CLOCK). When

AMOUNT is selected, the footpedal controls the amount of the LFO on the selected

channel. When OFFSET is selected, the footpedal controls the offset of the LFO on the

selected channel.

LFO OFF MODE allows you to select how the Multi-Pedal responds when the LFO

Channel is switched OFF from a footswitch. A setting of ‘INITIAL’ will stop the LFO

when OFF, and re-start the LFO at the programmed INITIAL VALUE when switched

ON. A setting of ‘CURRENT’ will hold the LFO voltage at the current (static) last

value when switched OFF, and resume from that point when switched ON. A setting

of ‘CONTINUOUS’ maintains the current state of the LFO (Rate, Amount and Offset)

when switched OFF, and resumes from that point when switched ON. In other words,

‘CONTINUOUS’ turns OFF the footpedal control of the LFO, while continuing to

output the LFO waveform.

LFO RATE sets the initial LFO rate for the selected channel when a Preset is selected

(if no Sync signal is available). See the section entitled Low Frequency Oscillator

Parameters (page 33) for more information.

LFO SYNC selects the source for the LFO rate. See the section entitled Low Frequency

Oscillator Parameters (page 33) for more information.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

No comments

Moog MP-201 User Manual Page 25