Moog MP-201 User Manual download pdf (Page 47)

MP-201 User’s Manual

Page 48

MP-201 User’s Manual

Page 49

Appendix B - Caring for the MP-201 Multi-Pedal

Clean your MP-201 Multi-Pedal with a soft, moist cloth only – do not use solvents

or abrasive detergents. Heed all safety warnings. Don’t drop the unit. If you are

shipping your MP-201 Multi-Pedal to the factory for servicing, we recommend using

the original shipping carton, or an ATA approved Road Case. Shipping the Multi-

Pedal in a non-ATA case or packaging other than the original carton will void the

warranty.

AN IMPORTANT NOTE ABOUT SAFETY: Do not open the chassis. There are

no user serviceable parts inside. Maintenance should be referred to qualied

service personnel only.

Appendix C - Footpedal Adjustment

The footpedal is set at the factory to a pre-dened tension, but can be adjusted

to optimize the pedal action to your individual preference.

If you wish to adjust the footpedal tension, switch the Multi-Pedal off and discon-

nect all connections. Flip the Multi-Pedal over and place it on a soft, non-skid

surface. On the bottom, locate the adjustment access hole beneath the footpedal

mechanism. Place the supplied 2.5mm Allen wrench into the adjustment hole and

gently seat the wrench into the hex slot. Once the wrench is rmly seated, slowly

rotate the wrench to make the adjustment. To tighten the footpedal, turn the

wrench clockwise; to loosen the footpedal, turn the wrench counter-clockwise.

For either direction, rotate the wrench only about a quarter-turn and then check

the footpedal tension. Use small, quarter-turn movements, checking the tension as

you go until the desired footpedal action is achieved. Do not over-tighten.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

No comments

Moog MP-201 User Manual Page 47